Buy DIN EN SEAMLESS STEEL TUBES FOR PRESSURE PURPOSES – TECHNICAL DELIVERY CONDITIONS – PART 2. DIN EN Seamless steel tubes for pressure purposes – Technical delivery conditions – Part 2: Non-alloy and alloy steel tubes with specified elevated. Manufacturing program with average wall thickness (EN ). Vallourec supplies seamless steel tubes for pressure purposes in accordance with.
|Published (Last):||15 July 2016|
|PDF File Size:||20.38 Mb|
|ePub File Size:||13.3 Mb|
|Price:||Free* [*Free Regsitration Required]|
When tubes are specified in the order by d, dmin or Tmin the following equations, all in millimetres, shall apply for the calculation of outside diameter Dc, inside diameter dc and wall thickness Tc, instead of D, d and T for the relevant requirements in clauses 8.
Non-alloy steel tubes with specified room temperature properties 102162- the technical delivery conditions for two qualities, T1 and T2, of seamless tubes of circular cross section, with specified room temperature properties, made of non-alloy quality steel…. Non-destructive testing for test category 2 tubes for detection of laminar imperfections see 8. Need more than one copy?
Responsible for test execution. Boiler tubes Boiler tubes are used in heat exchange appliances in which the energy is transferred from one medium to the other.
The marking shall include the following information: Product analysis for the tubes shall be supplied. If the document is revised or amended, you will be notified by email.
Your email address will not be published. Seamless steel tubes for pressure purposes — Technical delivery conditions — Part 1: Tensile testing at elevated temperature see 8. Seamless steel tubes for pressure purposes — Technical delivery conditions — Part 5: Unless option 16 is specified, the selection of the test method is at the discretion of the manufacturer.
110216-2 addition, the general technical delivery requirements specified in EN shall apply.
EN 10216-2 10CrMo9-10 Seamless Alloy Steel Tube
This standard is also available to be included in Dinn Subscriptions. Test pressure for hydrostatic leak tightness test see The test method is specified by the purchaser. The tube shall withstand the test without showing leakage or visible deformation.
ENMetallic materials – Tensile testing – Part 1: NOTE The definition of level 1, 2 and 3 can be found in appropriate standards e. To consider the test unit as conforming, after testing the second set, the following conditions shall be satisfied simultaneously: Tubes shall be delivered in exact lengths and the length shall be specified at the time of dim. We have no document history for this standard.
Welded steel idn for pressure purposes — Technical delivery conditions — Part 1: However, slight incipient cracks at its edges shall not be regarded as justification for rejection.
The delivery length range shall be agreed at the time of ordering. Additional marking, as agreed upon at the time of ordering, shall be applied.
din en 10216 2 steel pipe
Set of dimensions other than D and T see 8. The decision shall dln at the discretion of the manufacturer, but shall be stated to the customer at the time of ordering. Restriction on copper and tin content see table 2. The tubes shall be delivered with bevelled ends see figure 1.
Din En 2 Steel Pipe, Din En 2 Steel Pipe Suppliers and Manufacturers at
All tubes except group A. Unless option 1 102216-2 specified, the tubes may be either hot or cold finished at the discretion of the manufacturer. Non-alloy steel tubes with specified room temperature properties This Part of EN specifies the technical delivery conditions for two qualities TR1 and TR2 of welded tubes of circular cross section, made of non-alloy quality steel and with specified room tempe….